Yanhua ACDP Connect via Android Hotspot with/Without Scanning
In the previous post, we have shared how to connect wifi for Yanhua Mini ACDP via Android/IOS with/without scanning. Today we share another guide for connecting Mini ACDP via Android hotspot with/without scanning.
PART 1: ACDP connect via Android hotspot with scanning
1. Operating system requirement:
Make sure the Android system version is 7.0 or later
And the storage space is over 1.5 G.
ACDP requirement:
Make sure there is a ‘scan’ mark on the back of the ACDP host.
2. Setup on Android phone
Go to settings on your phone
Select Privacy>> Location service
Make sure the location service is turn on
Go back to the phone’s settings page
Select APP management>> App list
Click Mini ACDP>> Permissions
Make sure the location is on ‘While using’ or ‘Allow all the time’
Back to settings page
Click ‘Bluetooth’ and turn on
Make sure Wi-Fi is Off status
Click Connection & sharing>> Personal hotspot>> Personal hotspot settings
Keep the hotspot name and password as simple as possible
Select AP band ‘2.4 GHz band’
Set the ‘Visible to other devices’ to ON status
Note: When turned off, this hotspot can be connected manually.
Turn on personal hotspot
Select connection management>> Data restriction>> Unrestricted
Make sure ‘Automatically turn off personal hotspot when idle’ is Off status
3. Connect hotspot on Mini ACDP APP
Open Mini ACDP APP
Click ‘Settings’ in the upper left corner
Click ‘Initial use settings’
Make sure the Bluetooth and location service are On status
When there is a ‘scan’ mark on the back of the ACDP host, click ‘Yes’.
Scan the QR code on the back of the Mini ACDP host
Manually enter the hotspot name and password
Click ‘Start configuration’
After the device is bound successfully, the routine will automatically jump to the main screen. The connection information will show in the upper right corner of the main page.
PART 2: ACDP connect via Android hotspot without Scanning
The operating system requirement, the guide of Android phone setup, and Mini ACDP setting is the same as part1.
The difference is that make sure there is no a ‘scan’ mark on the back of the ACDP host.
When there is no ‘scan’ mark on the back of the ACDP host, click ‘No’.
Long press ‘SET’ button on Yanhua ACDP about 7 seconds, ACDP sounds a short one of beep, keep pressing.
The ACDP host beeps twice, and start initial programming, keep pressing.
Then ACDP host makes a long beep and finish initial programming.
Release the ‘SET’ button
Select the right device to connect
Manually enter the hotspot name and password.
Click ‘Start configuration’
After the device is bound successfully, the routine will automatically jump to the main screen. Connection information will show in the upper right corner of the main page as well.
