ship from eu/uk no tax

Carprog Full V8.21 user manual

Powering up the carprog full v8.21:
CarProg can be used with external power supply (+7 - +12V
stabilized), only with USB connection or with diagnostic cable ( for ex. OBDII)
• Standard power socket (positive in the middle) voltage in range +7…14V
stabilized can be used in any cases. Use it when +12V voltage is required
(Transponder read/write, some MCU`s read/write)

• USB power from PC - 5V, 100mA:
Always must be connected because USB cable
is used for Device – PC communication. Is enough for small power consumption
operations (i.e. EEPROM read/write)
• Using standard Car diagnostic Cable
• Installing Carprog clone software:
Copy software from CD or from your support page on to any directory on your PC. Main CarProg file can be older version, just
click on Update-Internet and CarProg will by updated automatically.
After update CarProg software must restart automatically and CarProg hardware update
must be done. Don’t disconnect CarProg USB cable while update process. If updates fail,
try again.

This is from EOBDTOOL website technical support: Carprog Full V8.21 user manual