1. Plug the N3+ into the power supply or connect the OBD to the test vehicle, and plug in the N3+’s USB cable.
2. Turn on the computer and plug in the computer USB cable.
3. Open the computer network configuration interface, find the Realtek USB FE Family Controller network
4. Click Properties--TCP/IPV4, and set the IP address as shown in the figure below.
5. Click OK to complete the wired network configuration.
6. On the same computer, if you replace a new N3+, you need to reset the IP. After the setting is completed, the computer is bound to the N3+. After disconnecting the USB cable, the network icon will disappear, and you don’t need to set the IP address again when you use the N3+ after the computer is wired or wirelessly connected to the Internet. .
7. Use the BMW special inspection software to test normally.
8. When using wireless detection, you need to unplug the USB cable on the computer first, and then you will find that the SSID is N3+ICOM-****, connect directly, enter the password 123456789, and you can use the BMW special inspection software directly without equipment.
9. When using the J2534 function of N3+ to test Mercedes-Benz, Toyota, Volkswagen, Honda, Land Rover, etc., first open the special inspection software, install the J2534 driver, select the PassThru menu in the special inspection software, select the ISO J2534 device in the list, and plug it in. For the USB connection cable between the computer and N3+, press and hold the N3+ switch button for 3 seconds, and the wired and wireless indicator light of the N3+ host will flash to test normally.
10. Use the DOIP function of N3+ to test the DOIP protocol of the new Mercedes-Benz, Volkswagen, Land Rover, etc.: first plug in the USB cable between the computer and N3+, press and hold the N3+ switch button for 3 seconds, the wired and wireless indicator light of the N3+ host flashes, and then turn on the computer For wireless, find N3+ ICOM-**** wireless, connect directly, enter the password 123456789, start the special inspection software, find the DOIP menu and test directly.
11. N3+ is a special inspection tool for BMW. It runs 100% of the special inspection program for BMW. The multi-function of N3+ is an auxiliary function. Within the test range of J2534 and DOIP, the result is consistent with that of the special inspection, but it cannot include all the functions and models of the special inspection. It is mainly for the CAN, K, DOIP function detection of new OBD models. It can replace J2534 detection line and ENET line.
