launch x431 Tool

Three Ways to Connect Xhorse MLB Solder Free Adapter to MLB Tool

Xhorse MLB Solder Free Adapter Kit is available at EOBDTool.co.uk now. It is specially designed to work with VVDI MLB Tool for VW, Audi, Lamborghini, Bentley and Porsche MLB key programming without soldering. Just need to remove 2 capacitors using a plier. Much easier and safer!

Here are 3 ways to connect Xhorse MLB Solder Free Adapter to MLB Tool.

Connection method:

Step 1: Remove Capacitors from the Original Key

i.e. Xhorse VVDI Key Tool Plus Pad

Connect the Xhorse MLB Tool to VVDI Key Tool Plus Pad using an OTG converter.

USB A to C Cable is connected to MLB Tool
USB (OTG) Cable is connected to Key Tool Plus

Navigate to: Immo Programming>> Audi >> Select by Type>> MLB Immobilizer Systems

Select the corresponding key type and check the wiring diagram.

Remove the two capacitors from the original key as indicated in the diagram.

Step 2: Connect the MLB Solder-Free Adapter to Original MLB Key Board

Align the pins on the adapter with the contacts marked on the wiring diagram.

Fasten the buckle securely:

The short side of the buckle should face upwards.

The long side, marked in white, should face downwards.

Step 3: Connect MLB Adapter to MLB Tool

Attach the Xhorse MLB Adapter to the key.

Connect the MLB Adapter to the MLB Tool, ensuring proper orientation.

Ensure the adapter ends up in the sensing area for accurate detection.

Step 4: Add a Spare MLB Key

Now, follow the key programming guide below to add a spare MLB key.

(Just skip the soldering steps if you're using the solder-free adapter)

http://blog.eobdtool.co.uk/vvdi-mlb-tool-and-key-tool-plus-add-audi-a4l-key/

www.eobdtool.co.uk

Back to top