How to Connect JLR DoIP VCI Pathfinder Interface via WiFi and USB

---

Part 1: How to Connect Original JLR DoIP VCI via WiFi?

Original Jaguar Land Rover diagnostic tool JLR DoIP VCI supports both USB and WiFi connection. Here's the guide to configure the LAN setting.

Procedure:

Connect JLR DoIP VCI W-F interface with vehicle

Connect the other end of VCI with laptop via USB cable

Open VCI Manager (JLR), press Connect


Choose Network Setup tab->Wired Etherent


Tick Enable Wired Etherent Interface


Press Apply button and Yes


Then disconnect USB connection

Close VCI Manager

Open VCI Manager again

Press Connect

Go to Network Setup->Wired Etherent

Press Set Factory Default

Press OK if system prompts you are about to reset the VCI communication settings to a factory default state.


Enable network connection

Press Set Factory Default again


In Wireless (802.11), choose Obtain an IP address automatically, then press Access Point


Choose Wireless resource which is the same as the your network
Press Configure


Enter wireless security password (encryption key)

Press Next


JLR VCI is configured to connect to your network

Disconnect and then Connect VCI


It shows WiFi connection is done

Open JLR SDD software on desktop


Press Connect

Now you can run SDD software for diagnosis


Part 2: How to connect JLR DoIP VCI via USB 

To setup USB connection, you need to download Bosch driver for VCI first:

 
Open Bosch_Driver folder

Open MTS6533_Setup

Install Bosch VCI Software (JLR)
Press Next
Press Next
Press Install
Finish installing Bosch VCI software


USB Configuration in progress. Don’t disconnect JLR VCI from PC until a message indicates that the configuration process has completed.


Open Device Manager to check the Bosch JLR DoIP VCI adapter is well connected

Open VCI Manager on desktop to make sure the Manager detect JLR VCI which indicates interface is well connected


Right click JLR SDD software on desktop->Find File location C:/Program Files/JLR/SDD/Runtime

Open the GatewayManager with Notepad
Find “Device5 = JLR-DOIP” and change value to “,  Device5 = JLR-DOIP”


Find Go to C:/Program Files/JLR/IDS/Runtime


Open the GatewayManager with Notepad
Find “Device5 = JLR-DOIP” and change value to “,  Device5 = JLR-DOIP”


Setup completed.

Now you can run JLR SDD and Pathfinder software