launch x431 Tool

Tips on Using KTMflash and KTM OBD ECU Programmer & Gearbox Power Upgrade Tool


Tips on using KTMflash and KTM OBD ECU Programmer

1. You have to use software from us
 
2. ECU flash and the like cannot be installed in your PC/laptop before; that is, for your PC/laptop, it must be the first time to install KTMflash software.
You’re asked to re-install a clean operation system and install KTMflash sw with the help of a video of installation tutorial; otherwise, your device would be locked.
And better do NOT CONNECT INTERNET, or will lock the device.
 

3. Here are folders (KTMflash English... and KTMflash software...) inside the CD you should have. You can find out software and real tests which helps you a lot to use KTM flash.
 
4. The reason for why do you buy KTMflash is that, it’s good at reading Infineon ECUs and gearbox (transmission) ECU.
 
5. When you are reading encypted Infineon or ECUs, please read the password file (with reference to our video here). 
If the sw asks you to TURN OFF THE POWER SUPPLY FOR 2 SECONDS, please follow it.If the power is not off for 2 seconds, the pop-up might be appeared again in the interface. So, just turn it off for 2s and use the sw.
 
6. About switching, must watch our video and instructions.
 
7. Recommend use Intel processors Computer ; Computers with AMD processors can only do one time !